MOSIL 45° Bent Elements

In the cases where electrical connections cannot be done above the roof, bent elements are used. Sometimes the furnace is too high to allow installation of elements suspended from the roof, this is due to the limitation regarding the maximum permitted heating zone length. So, in such scenarios, it is necessary to install elements with bent terminals or heating zones. Most elements are bent in the cold end, but they can also be bent in the hot section. The MOSI2 45˚ bent element have their cold terminals bent at a 45˚ angle. This allows the installation of several rows of such heating elements on a wall of the furnace and it is also possible to control the power at different levels inside the furnace.

The furnace temperature can be limited to 1600°C (2910 ° F) by using bricks or fibres to support the terminals of the furnace.

Two-Shank  MOSIL  1700  6/12

• Max.Element temperature 1700^o C (3090^o F)
• Heating zone ø mm 6
• Terminal ø mm     12

(Power – W,  Resistance – Ω,  Volt –V)

Heating Zone L_e ———->

Two-Shank  MOSIL  1700  9/18

• Max.Element temperature 1700^o C (3090^o F)
• Heating zone ø mm 9
• Terminal ø mm     18
•  Shank distance mm 60

(Power – W,  Resistance – Ω,  Volt –V)

Two-Shank  MOSIL  1700  12/24

• Max.Element temperature 1700^o C (3090^o F)
• Heating zone ø mm 12
•  Terminal ø mm     24
• Shank distance mm 80

(Power – W,   Resistance – Ω,  Volt –V)

Two-Shank  MOSIL  1800  3/6

• Max.Element temperature 1800^o C (3270^o F)
• Heating zone ø mm 3
• Shank distance mm 25

(Power – W,  Resistance – Ω,  Volt –V)

Two-Shank  MOSIL  1800  4/9

• Max.Element temperature 1800^o C (3270^o F)
• Heating zone ø mm 4
•  Terminal ø mm     9
• Shank distance mm  25

(Power – W,  Resistance – Ω,  Volt –V)

Two-Shank  MOSIL  1800  6/12

• Max.Element temperature 1800^o C (3270^o F)
• Heating zone ø mm 6
• Terminal ø mm    12
• Shank distance mm  50

(Power – W,  Resistance – Ω,  Volt –V))

Two-Shank  MOSIL  1800  9/18

• Max.Element temperature 1800^o C (3270^o F)
• Heating zone ø mm 9
•  Terminal ø mm    18
• Shank distance mm  60

(Power – W,  Resistance – Ω,  Volt –V)

Two-Shank  MOSIL  1800  12/24

• Max.Element temperature 1800^o C (3270^o F)
• Heating zone ø mm 12
• Terminal ø mm    24
•  Shank distance mm  80

(Power – W,  Resistance – Ω,  Volt –V)

Download the MOSIL Range of Molybdenum Di-Silicide Heater Brochure